Gas Cutting Set Inspection Checklist
Company Name :
Date of Inspection :
Make :
Model :
Number :
Owned/Hired/Contractor :
Check Points for inspection of Gas Cutting Set:
| SN | Details |
| 1 | Cylinder should always be kept in trolley. |
| 2 | Always keep cylinder in upright position and secured. |
| 3 | Always ensure valve protection cap with it. |
| 4 | Regulator should be of standard and free from defect. |
| 5 | Pressure gauge should be in good condition, without any defect. |
| 6 | Hose pipe is in good condition and colour coded as per standard. |
| 7 | Joint should be tight enough and without any defect. |
| 8 | Must use Industrial clip for fitting. |
| 9 | Flash back arrestor should be provided at both end (At cylinder pressure gauge and at torch hose pipe). |
| 10 | Always use industrial type lighter (No matchbox / Commercial Lighter allowed) |
| 11 | Proper Personal Protective Equipment-PPE should be used while use for e.g., Safety Goggles, Leather Apron, Leather hand gloves, etc. |
| 12 | Torch should be in good condition, without any defect. |
| 13 | First Aid Kit and Fire Extinguisher should be available at work place. |
| 14 | Provide booth if required. Refer image in box for ideal Gas Cutting Station. |
| 15 | Competent person only should carry out gas cutting work. |
correct and safe oxygas welding station Global EHS| Inspection Done By: |
| Name: |
| Department: |
| Designation: |
| Signature: |
| Date: |
| Review Done By: |
| Name: |
| Department: |
| Designation: |
| Signature: |
| Date: |
